Ons assortiment
Of het nu gaat om hydroliek, elektronica of een combinatie van deze. HB Technologie is thuis in de materie, zowel voor nieuwbouw als revisie. Ook kunt u bij HB Technologie terecht voor reparatie en revisie van Barber-Colman apparatuur. Uiteraard ondersteunen wij ook vele andere leidende merken. Informeer vandaag nog bij ons naar de mogelijkheden voor uw project.
Our assortment
Whether it concerns hydraulics, electronics or a combination of these, HB Technologie is at home in the matter, both for new construction or overhaul. You can also contact HB Technologie for repair and overhaul of Barber-Colman equipment. Of course we also support many other leading brands. Contact us today about the possibilities for your project
The MNS is a basic, microprocessor controlled unit designed to monitor 3-phase mains voltages, send remote start commands to the generating set, and manage changeover of both the generator and the mains contactors.
The genset should be controlled by a Remote Start control unit.
The ICGEN 2.0 is a complete auto transfer switch controller with remote start/stop for a single generating set operating in standby mode.
All mains parameters are checked and in case of failure, the controller will provide a remote start signal to the generator.
When the mains reappear, the ICGEN 2.0 opens the genset breaker, switches back the load on the mains and stops the generator after a programmable cooling time.
The ACGEN 2.0 is a complete auto start controller with remote start/stop for a single generating set operating in standby mode. The ACGEN 2.0 controller is used for automatic and manual control of generators.
The test feature allows you to set various daily or weekly self tests of the generator.
The module also handles OpEx feature for the control of fuel costs.
The CRE Technology unit MDA is a low cost, microprocessor controlled unit designed to start and stop the genset automatically on request of an external Remote Start signal.
It has high power relay outputs enabling it to interface directly with diesel gensets.
The MDM unit from CRE TECHNOLOGY is a basic, microprocessor controlled unit designed to start and stop the genset manually using the key switch and pushbuttons on the front panel. It has high power relay outputs enabling it to interface directly with diesel gensets.
When the engine is running, the unit monitors fault conditions and shuts down the engine automatically if an alarm occurs. The alarms are identified by LEDs.
This unit is perfect for backup mode solution.
- Complete engine control of diesel, gasoline or gas gensets (preheating, pre-glow, ignition, start/stop…).
- Alternative or consecutive multiple starter management.
- Warmup & Cool down at idle or nominal speed.
- Remote start and test mode available ON/OFF load.
- Compatible with all J1939 electronic engines.
- Mains failure detection and changeover with adjustable load transfer time.
- Override mode (protections inhibition + dedicated hour meter) following NFE 37-312 certification.
- Non-essential load control on overload.
- Battery Boost management.
- Configurable maintenance cycle.
- 2 password levels.
- Complete engine control of diesel, gasoline or gas gensets (preheating, pre-glow, ignition, start/stop…).
- Alternative or consecutive multiple starter management.
- Warmup & Cool down at idle or nominal speed.
- Remote start and test mode available ON/OFF load.
- Compatible with all J1939 electronic engines.
- Mains failure detection and changeover with adjustable load transfer time.
- Override mode (protections inhibition + dedicated hour meter) following NFE 37-312 certification.
- Non-essential load control on overload.
- Battery Boost management.
- Configurable maintenance cycle.
- 2 password levels.